§ 1926.954 Personal protective equipment.
(a) General. Personal protective equipment shall meet the requirements of subpart E of this part.
Note to paragraph (a):
Paragraph (d) of § 1926.95 sets employer payment obligations for the personal protective equipment required by this subpart, including, but not limited to, the fall protection equipment required by paragraph (b) of this section, the electrical protective equipment required by § 1926.960(c), and the flame-resistant and arc-rated clothing and other protective equipment required by § 1926.960(g).
(b) Fall protection—(1) Personal fall arrest systems. (i) Personal fall arrest systems shall meet the requirements of subpart M of this part.
(ii) Personal fall arrest equipment used by employees who are exposed to hazards from flames or electric arcs, as determined by the employer under § 1926.960(g)(1), shall be capable of passing a drop test equivalent to that required by paragraph (b)(2)(xii) of this section after exposure to an electric arc with a heat energy of 40±5 cal/cm .
(2) Work-positioning equipment. Body belts and positioning straps for work-positioning equipment shall meet the following requirements:
(i) Hardware for body belts and positioning straps shall meet the following requirements:
(A) Hardware shall be made of drop-forged steel, pressed steel, formed steel, or equivalent material.
(B) Hardware shall have a corrosion-resistant finish.
(C) Hardware surfaces shall be smooth and free of sharp edges.
(ii) Buckles shall be capable of withstanding an 8.9-kilonewton (2,000-pound-force) tension test with a maximum permanent deformation no greater than 0.4 millimeters (0.0156 inches).
(iii) D rings shall be capable of withstanding a 22-kilonewton (5,000-pound-force) tensile test without cracking or breaking.
(iv) Snaphooks shall be capable of withstanding a 22-kilonewton (5,000-pound-force) tension test without failure.
Note to paragraph (b)(2)(iv):
Distortion of the snaphook sufficient to release the keeper is considered to be tensile failure of a snaphook.
(v) Top grain leather or leather substitute may be used in the manufacture of body belts and positioning straps; however, leather and leather substitutes may not be used alone as a load-bearing component of the assembly.