§ 4.6 Labor standards clauses for Federal service contracts exceeding $2,500.

The clauses set forth in the following paragraphs shall be included in full by the contracting agency in every contract entered into by the United States or the District of Columbia, in excess of $2,500, or in an indefinite amount, the principal purpose of which is to furnish services through the use of service employees:

(a) Service Contract Act of 1965, as amended: This contract is subject to the Service Contract Act of 1965, as amended (41 U.S.C. 351 et seq.) and is subject to the following provisions and to all other applicable provisions of the Act and regulations of the Secretary of Labor issued thereunder (29 CFR part 4).

(b)

(1) Each service employee employed in the performance of this contract by the contractor or any subcontractor shall be paid not less than the minimum monetary wages and shall be furnished fringe benefits in accordance with the wages and fringe benefits determined by the Secretary of Labor or authorized representative, as specified in any wage determination attached to this contract.

(2)

(i) If there is such a wage determination attached to this contract, the contracting officer shall require that any class of service employee which is not listed therein and which is to be employed under the contract (i.e., the work to be performed is not performed by any classification listed in the wage determination), be classified by the contractor so as to provide a reasonable relationship (i.e., appropriate level of skill comparison) between such unlisted classifications and the classifications listed in the wage determination. Such conformed class of employees shall be paid the monetary wages and furnished the fringe benefits as are determined pursuant to the procedures in this section.

(ii) Such conforming procedure shall be initiated by the contractor prior to the performance of contract work by such unlisted class of employee. A written report of the proposed conforming action, including information regarding the agreement or disagreement of the authorized representative of the employees involved or, where there is no authorized representative, the employees themselves, shall be submitted by the contractor to the contracting officer no later than 30 days after such unlisted class of employees performs any contract work. The contracting officer shall review the proposed action and promptly submit a report of the action, together with the agency's recommendation and all pertinent information including the position of the contractor and the employees, to the Wage and Hour Division, U.S. Department of Labor, for review. The Wage and Hour Division will approve, modify, or disapprove the action or render a final determination in the event of disagreement within 30 days of receipt or will notify the contracting officer within 30 days of receipt that additional time is necessary.

(iii) The final determination of the conformance action by the Wage and Hour Division shall be transmitted to the contracting officer who shall promptly notify the contractor of the action taken. Each affected employee shall be furnished by the contractor with a written copy of such determination or it shall be posted as a part of the wage determination.

(iv)

(A) The process of establishing wage and fringe benefit rates that bear a reasonable relationship to those listed in a wage determination cannot be reduced to any single formula. The approach used may vary from wage determination to wage determination depending on the circumstances. Standard wage and salary administration practices which rank various job classifications by pay grade pursuant to point schemes or other job factors may, for example, be relied upon. Guidance may also be obtained from the way different jobs are rated under Federal pay systems (Federal Wage Board Pay System and the General Schedule) or from other wage determinations issued in the same locality. Basic to the establishment of any conformable wage rate(s) is the concept that a pay relationship should be maintained between job classifications based on the skill required and the duties performed.

(B) In the case of a contract modification, an exercise of an option or extension of an existing contract, or in any other case where a contractor succeeds a contract under which the classification in question was previously conformed pursuant to this section, a new conformed wage rate and fringe benefits may be assigned to such conformed classification by indexing (i.e., adjusting) the previous conformed rate and fringe benefits by an amount equal to the average (mean) percentage increase (or decrease, where appropriate) between the wages and fringe benefits specified for all classifications to be used on the contract which are listed in the current wage determination, and those specified for the corresponding classifications in the previously applicable wage determination. Where conforming actions are accomplished in accordance with this paragraph prior to the performance of contract work by the unlisted class of employees, the contractor shall advise the contracting officer of the action taken but the other procedures in paragraph (b)(2)(ii) of this section need not be followed.